Top 5 Things To Do To Winterize Your Outside and Inside Faucets

Outside, you’ll find various types of faucets in most houses. Regardless of whether they are used for cooking or watering crops.

Both kinds have shown up in our encounters, in my opinion. We’ve also lived in colder climates, where you have to worry about your exterior faucets growing and bursting.

Some of the most important things you can do to prepare your faucets for winter are turning off the interior and outside valves, draining the lines, removing your hoses, administering short bursts of compressed air to the pipes, and protecting the pipes.

Reasons why your faucets need to be winterized

Water expands when it freezes. Expanding water can cause many issues in and around your home. Included in this are the water supply hoses and faucets you use. Because of this, winterizing your faucets is a need.

You should take precautions to ensure that your faucets and the pipes that link to them do not expand and break. It’s also possible to prevent this from happening.

Recommended: Top 4 Steps To Storing Wood Outside

1. Draining and storing your hoses is step one.

Your exterior faucets are typically used for watering grass and trees or simply for convenient access to the water supply. There was no sprinkler system and only an above-ground faucet to water the grass at one of our properties. Leaving the hoses attached to the faucets may be the simplest option.

But if you leave the hoses attached to the faucets in the winter, you may find yourself in a predicament when the temperature drops. You’ll need to remove the hoses from the faucet to get started. Once the hose has been detached, you must roll it up and store it.

When you roll up the hose, you accomplish two things: This allows you to easily store it away over the winter as a first step. Wrap up the hose to save space and make it easier to store. It is also necessary to roll up the hose to evacuate all water.

The hose is less likely to be destroyed by expanding water in the cold winter if all the water has been drained from it. Wrap the hose around your elbow and back through your hand, starting with the end you’re holding in your hand.

To get the water to flow out of the end of the hose, simply roll it around your hand several times. And avoid putting mud all over your hands, arm, and clothes; you can simply pick a slope in your neighborhood to roll the hose up.

The hose’s lower end should be on the slope if you have a slope. The hose will eventually run dry.By whirling it in a circular motion, you may roll the hose up on the ground. Make sure to put your hose indoors for the winter, either in your garage or in your house, after wrapping it up.

Recommended: Top 3 Tips to Winterize Your Garden Strawberries

2. Turn off both valves on the interior and exterior of the water heater.

A shut-off valve is exactly what it sounds like: it stops the flow of water to a certain faucet. Removing water from a particular faucet will help flush out any remaining water and prevent someone from turning it on and causing more problems for you, so shutting off the water is the best option.

Two possibilities are available when it comes to the water’s shut-off switch location. That valve is likely to be located inside the house for water meant for human use.

The first step is to locate the water heater in either your basement or in a “water closet” and see if there are any valves that can be opened and shut. Before you can locate the shut-off valve, you may have to spend some time tracing the path of the pipes.

It’s much easier to locate a certain shut-off valve because they’re all in the same closet in our house. It’s a different situation when turning off the irrigation water valve.

Your city may switch off the irrigation water before you have a chance to do so. Everything except storing your hoses for the winter will be fine if that is the case.

Unless your city turns off the irrigation water, you will need to figure out where your side of the irrigation water is located. Somewhere in your yard, you’ll likely find this item.

It’s most likely in the neighborhood where you live.I once had to sift through all the gravel in our yard to find ours.

Find it and write it down so you can find it again in the future. Once you’ve found it, remove the top to reveal either a gate valve or a ball valve inside the green box.

Turn the gate valve counterclockwise until it stops turning. After then, it will be shut down. The handle of a ball valve is a knob. If the handle is parallel to the pipe, the valve is open, or the handle has been switched on.

A closed pipe is achieved by rotating the ball valve perpendicular to the pipe’s axis. Close the valve and continue the process.

3. Draining the piping system

Open the faucets to drain any remaining water after turning off the water supply (through the valves) at the faucets. It’s time for the water to drain out, so open the taps!

Recommended: Are Trampolines Bad For Your Back?

4.  Inhale a burst of air at a time

Additionally, you’ll need to blow some air into the pipes to clean them out. The bursts of air will expel any residual water in the pipes.

For the greatest results, use an air compressor. If you don’t have access to an air compressor, you can get by with short bursts of air from a can. To avoid overfilling the pipes, use short bursts of air. If you observe water draining from the pipe, keep applying the small bursts of pressure until it stops.

5. Protection of the pipes can be achieved by

The last line of defense is to provide some safeguards to the pipes themselves. Insulating jackets for pipes are included in this. Amazon has a selection of these jackets.

Protecting the pipes from freezing and overheating is made easier by using pipe insulating material. It should be a simple matter to slide it over the pipes.

Recommended: Top 5 Ways to Winterize Your Lawn Mower

Conclusion

Leaving your pipes unattended during the winter may seem like a simple solution. Even if this may be the case, you could lose at least 50 gallons of water per minute if you have a burst pipe. So, plan and do what you need to accomplish.

Keep an eye out for anyone who might try to use the faucet. To avoid calling a plumber to remedy a major water leak, simply follow the five procedures outlined above.

Leave a Comment